| Add me on Facebook (click the LIKE button on Facebook to add me) http://www.facebook.com/brusspup Download the song in this video: Song Name: Break Emotion iTunes: https://itunes.apple.com/us/album/break-emotion-single/id399452730 Thanks to DxDutch for all of her help on this video and many others. Be sure to check out her channel http://www.youtube.com/dxdutch The kitty in the video is Hyder. She has her own channel: http://www.youtube.com/hyderkitty This demonstration is 100% real. It's relatively simple to create your own. Check out some extra footage here: http://youtu.be/09_Cda9Rl5o This video shows you how to create a secret LCD monitor. The first time I read that you could do this, I just had to try. The results are amazing. If you are going to try and make your own, there are a few things to keep in mind. First, I would recommed using a monitor that you don't care about. I bought mine from a pawn shop for $20 dollars. Once you remove the polarized layer, you've pretty much made the monitor useless as to normal use. If you are good with repairs and that sort of thing, I'm sure you could buy a replacement filter to fix the monitor. So basically, just make sure you are ok with modifying whatever monitor you've chosen to use for this project. Once you have your monitor you need to remove the top layer, which is the polarized layer. It helps to remove the plastic frame from the front but it's not 100% necessary. Once you remove the plastic front, use a hobby knife to cut on the edge around the whole monitor. Press hard enough to make the cut but don't press too hard. That's once thing to keep in mind during this whole process is that you can completely destroy the monitor by damaging the actual LCD part of the screen. Once you make the 4 cuts, then pick a corner to start peeling the polarized layer. I used a hobby knife to "dig" under the layer so I could get a big enough piece to grab onto. Now, every monitor is different so you may experience this part a little different than the next person. You want to peel slowly to try and get the biggest pieces possible and also not to put too much force on the screen. This part could take several minutes to get all of the polarized layer off. Most LCD monitors have an antiglare layer "attached" to the polarized layer and both of those layers are glued so the hard surface of the LCD. So you may see these extra layers as you are removing them. If you're lucky you will be able to remove all 3 layers by just pulling it off. But it's likely that some glue will be left over. It's also possible that you will lift the polarized and antiglare layer but leave most of the glue. If you look closely in my video, you can see a few spots where the contrast is different. These are spots where the glue came off. If there are a lot of glue spots and it bothers you, it is possible to remove the glue by using paint thinner. But you have to be very careful. If you use the paint thinner, apply it to the glue spots |
| Views: 2230257 | 2013-10-29 |